FOAM CUTTERS |
 |
 |
|||||
|
|||||||
|
|||||||
HEAT DIAL
|
|
|
| This is limited-time-use
tool. To avoid overheating and damaging the tool, depress the trigger for 15 seconds, then release the trigger for 15 seconds. Continue this cycle for a maximum of 5 minutes. Then let the tool rest for 2-1/2 minutes. Using the tool longer than 5 minutes at a time will cause heat damage and is not covered by the warranty. |
| ITEM # | |
|
| HDHKT | Heat Dial Hot Knife Tool | $ 243.85 |
| HD200 | 2" Blade, Pack of 2 | 23.00 |
| HD400 | 4" Blade, Pack of 2 | 24.00 |
| HD600 | 6" Blade, Pack of 2 | 28.00 |
| HDANGLE | Angle Straight Edge Adapter | 36.00 |
| HD6 | 6" Groover Plate | 96.95 |
| HD6G | 6" Groover Plate with Guide | 96.95 |
| HDC220 | 220 Volt Converter | 39.95 |
| CASEH | Hot Knife Hard Case | 25.00 |
| CASEA | Hot Knife Aluminum Case | 55.00 |
| |
HDHKT, Heat Dial Hot Knife Tool -- $243.85 | |
| |
See Heat Dial Hot Knife Blades |
|
| |
NWFW, Flat Ni-Chrome Wire, per
foot -- $10.00 WCP, Wire Crimping Tool -- $18.00 |
|
|
220-VOLT CONVERTER
|
| |
HDC220, 220 Volt Converter -- $39.95 |
|
||||||
|
1055 Nine North Drive, Alpharetta, GA 30004 USA
TOLL FREE: 1.800.325.7540
TEL: 770.772.7448 FAX: 1.888.534.8383
Contact Form